UPDATES | cooperstrike

Cooper Strike Introduction

We began the soldering process on the breadboard, knowing that the laser diodes, the 4 segment displays, and the solenoid valves require...

We have installed the netting that will hold the ping pong balls into the frame. For the netting material, we bought a stretchable...

We have successfully configured all of our pneumatic components. A 1/4" hose with quick disconnect fittings on either end will connect...

Acrylic was used as the material for the player's viewing window because it provides a sturdy yet transparent barrier between the player...

We used polyethylene film for the the observers viewing window. The edges of the film were lined with duct tape and attached to the frame...

The entire pneumatic setup was tested out today. We brought the air compressor, along with all of our hoses and manifolds, from the 706...

Using the corner braces that we had remaining, we made a system for holding acrylic on the inside of the frame. The holder consists of...

The housing that is to be responsible for mounting the barrel of the blowgun onto the shaft is completed. The above housing has two...

Two aluminum manifolds were milled out. The rectangular shape of the manifold was first carved into shape using a 1/2'' endmill. Then,...